Traversing Axes By A Variable Increment - Siemens SINUMERIK 828D Operating Manual
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Execution in manual mode
3.3 Traversing axes
Note
When the control is switched on, the axes can be traversed right up to the limits of the
machine as the reference points have not yet been approached and the axes referenced.
Emergency limit switches might be triggered as a result.
The software limit switches and the working area limitation are not yet operative!
The feed enable signal must be set.
3.3.2
Traversing axes by a variable increment
Proceed as follows
110
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
1.
Select the "Machine" operating area.
Press the <JOG> key.
2.
Press the "Settings" softkey.
The "Settings for manual operation" window is opened.
3.
Enter the desired value for the "Variable increment" parameter.
Example Enter 500 for a desired increment of 500 μm (0.5 mm).
4.
Press the <Inc VAR> key.
5.
Select the axis to be traversed.
6.
Press the <+> or <-> key.
...
Each time you press the key the selected axis is traversed by the set
increment.
Feedrate and rapid traverse override switches can be operative.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling
Advertisement
Table of Contents
