Siemens SINUMERIK 828D Operating Manual page 81

Note
Settable work offsets
The selection of work offsets can be set differently.
The corresponding softkey is dynamically displayed and is aligned to the number of existing
settable work offsets.
Please also refer to the machine manufacturer's instructions.
Automatic measurement
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
7. Press the "Save P1" softkey.
The point is measured and stored.
8. Repeat steps 6 and 7 to measure and store measuring points P2, P3
and P4.
9. Press the "Calculate" softkey.
The diameter and center point of the spigot are calculated and
displayed.
- OR -
Press the "Set WO" softkey.
The setpoint position of the center point is stored as a new zero point
with "Set WO". The tool radius is automatically included in the
calculation.
1. Select the "Measure workpiece zero" function (see steps 1 and 2
above).
2. Press the "Rectangular spigot" softkey.
- OR -
Press the "1 circular spigot" softkey.
- OR -
Press the "2 circular spigots" softkey.
- OR -
Press the "3 circular spigots" softkey.
- OR -
Press the "4 circular spigots" softkey.
- OR -
Setting up the machine
2.6 Measuring the workpiece zero
81