5.5.3
Side view
Changing the display
You can increase or decrease the size of the simulation graphic and move it, as well as
change the segment.
5.6
Editing the simulation display
5.6.1
Blank display
You can change the blank defined in the program.
Note
The unmachined part can only be entered if simulation or simultaneous recording is in the
reset state.
Procedure
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1.
Start the simulation.
2.
Press the "Additional views" and "Side view" softkeys.
1.
The simulation or the simultaneous recording is started.
2.
Press the ">>" and "Blank" softkeys.
The "Blank Input" windows opens and displays the pre-assigned
values.
3.
Enter the desired values for the dimensions.
4.
Press the "Accept" softkey to confirm your entries. The new
dimensions are taken into account in the display of the workpiece.
Simulating machining
5.6 Editing the simulation display
161