Renumber Program; Editor Settings - Siemens SINUMERIK 828D Operating Manual

4.10.4

Renumber program

You can modify the block numbering of programs opened in the editor at a later point in time.
Requirement
The program is opened in the editor.
Procedure
Note
If you only want to renumber a section, select the program blocks whose block numbering
you want to edit.
4.10.5

Editor settings

Enter the default settings in the "Settings" window that are to take effect automatically when
the editor is opened.
Presettings
Settings
Number
automatically
First block number
Increment
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumber" softkey.
The "Renumbering" window appears.
3. Enter the values for the first block number and the increment to be
used for numbering.
4. Press the "OK" softkey.
The program is renumbered.
Meaning
Yes: A new block number will automatically be assigned after every line
change. In this case, the specifications provided under "First block number"
and "Increment" are applicable.
No: No automatic numbering.
Specifies the starting block number of a newly created program.
The field is only editable when "Yes" is available under "Number
automatically".
Defines the increment used for the block numbers.
The field is only editable when "Yes" is available under "Number
automatically".
Machining the workpiece
4.10 Editing a program
145