Actual Value Window - Siemens SINUMERIK 828D Operating Manual

1.4.3

Actual value window

The actual values of the axes and their positions are displayed.
WCS/MCS
The displayed coordinates are based on either the machine coordinate system or the
workpiece coordinate system. The machine coordinate system (MCS), in contrast to the
workpiece coordinate system (WCS), does not take any work offsets into consideration.
You can use the "MCS actual values" softkey to toggle between the machine coordinate
system and the workpiece coordinate system.
The actual value display of the positions can also refer to the SZS coordinate system
(settable zero system). However the positions are still output in the WCS.
Maximize display
Overview of display
Display
Header columns
WCS/MCS
Item
Display of distance-to-go
Feed/override
Repos offset
Footer
See also
Overview (Page 62)
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Press the ">>" and "Zoom act.val." softkeys.
Meaning
Display of axes in selected coordinate system.
Position of displayed axes.
The distance-to-go for the current NC block is displayed while the
program is running.
The feed acting on the axes, as well as the override, are displayed
in the full-screen version.
The distances traversed in manual mode are displayed.
This information is only displayed when you are in the "Repos"
submode.
Display of active work offsets and transformations.
The T, F, S values are also displayed in the full-screen version.
Introduction
1.4 User interface
31