Selecting A Block - Siemens SINUMERIK 828D Operating Manual

10.6

Selecting a block

You have the option of setting the interrupt pointer to the current cursor position. The next
time the program is started, processing will resume from this point.
With teach-in, you can also change program areas that have already been executed. This
automatically disables program processing.
You must press reset or select a block to resume the program.
Requirement
The program to be processed is selected.
Proceed as follows
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
7. Traverse the axes to the desired position and press the "Accept"
softkey.
The program block is taught with the modified values.
- OR -
Press the "Cancel" softkey to cancel the changes.
1. Select the "Machine" operating area.
2. Press the <AUTO> key.
3. Press the <TEACH IN> key.
4. Press the "Teach prog." softkey.
5. Place the cursor on the desired program block.
6. Press the "Block selection" softkey.
Teaching in a program
10.6 Selecting a block
349