Ricoh V-C3 D081 Field Service Manual page 525

9. Check the notations to the right.
• "ROM" shows the module number and version of the currently installed software.
• "NEW" shows the module number and version of software on the SD card in Slot 1 (lower slot).
10. Touch item that you want to update. The selected item appears in reverse black and white, and you
can select more than one
11. Touch [Update] or push [#] on the 10-key pad to start the update.
While the Update Is in Progress
• Remain with the machine. Do not leave it unattended.
• Never close the front door during firmware update.
• You will see a progress bar on the screen while the update is in progress.
• For some updates the [Start] key LED may flash RED slowly, while the update is in progress.
When it starts to flash RED rapidly, this means the update is nearly finished. When the LED flashes
GREEN this means the update is completed.
• Never switch the machine off while the [Start] key is flashing RED.
• If the machine is switched off or accidentally unplugged before the update is finished, do not
remove the SD card. Just switch the machine on again. The firmware update should restart
automatically. If the firmware update does not recover, obtain a new System SD card.
The following screen sequence appears after selecting one "OpePanel" selected for update.
Example: System/Copy Update
• The middle bar tells you the name of the item that you are updating.
• The bottom bar shows the progress of the update procedure.
Firmware Update
4
523