Ricoh V-C3 D081 Field Service Manual page 690

3. Appendix: Service Call Conditions
SC565 A
3
SC566 A
SC569 D
SC570 D
112
Heating roller fusing lamp on error
After fusing belt reached warm-up temperature, the heating roller fusing lamp
remained on for 20 sec. while the hot roller was not rotating.
• Do SP5810 to cancel the SC fusing code.
• Thermistor damaged, or out of position
• Fusing lamp disconnected, broken
Heating roller non-contact thermistor 3
Thermistor detected a temperature less than 0 degrees more than three times.
• Do SP5810 to cancel the error.
• Hot roller thermistor connector disconnected, loose, broken, or defective.
Pressure roller lift error 2
Pressure roller lift motor not operating correctly. (No signal to indicate completion of
operation.)
• Pressure roller lift sensor connection loose, broken, damaged
• Clean the pressure roller lift sensor
• Pressure roller lift harness loose, broken, damage
• Pressure roller lift motor blocked by an obstruction
• Pressure roller lift motor defective
Development intake fan error
Fan motor not operating correctly.
• Fan harness loose, broken, defective
• Fan overload due to physical obstruction
• Fan motor defective