Ricoh V-C3 D081 Field Service Manual page 725

Spine alignment error
During pin alignment operation, the pin did not reach the up position or return to
the home position with the prescribed time (400 ms), and one retry failed within
the same time limit.
• Alignment pin motor (M602) connector loose, broken, defective
• Motor overload
SC792-17 B
• Motor defective
• Alignment pin HP sensor (S604) connector loose, broken, defective, or
• Alignment pin up sensor (S610) connector loose, broken, defective, or
• Stack not jogged correctly, or not punched correctly
Binder unit not detected
The binder unit could not be detected at initialization.
SC792-18 B
• Drawer connector loose, broken, defective
• Drawer connector defective
Output belt unit rotation error
Detected at HP after the time prescribed to leave the HP had elapsed (more than
800 pulses) (1st detection, jam, 2nd detection, SC error)
-or-
Not detected at HP after the time prescribed to arrive at the HP had elapsed (more
than 2300 pulses) (1st detection, jam, 2nd detection, SC error)
792-19 B
• Output belt rotation motor (M403) connector loose, broken, defective
• Motor overload
• Motor defective
• Output belt rotation HP sensor (S403) connector loose, broken, defective
• Sensor defective
sensor defective
sensor defective
Service Call Tables
3
147