Ricoh V-C3 D081 Field Service Manual page 745

4. Appendix: Service Program Mode
Tables
Service Program Mode
Notation What it means
Example: [–9 to +9/0.1 mm]
The default setting can be adjusted in 0.1mm steps in the range ±9.
[range/step]
Note: The default setting for each SP mode is shown on the screen in the "Initial"
box immediately below the entry box.
DFU Denotes "Design or Factory Use". Do not change this value.
Japan Only The feature or item is for Japan only. Do not change this value.
LEF Long Edge Feed
SEF Short Edge Feed
Fin1 2000/3000-Sheet Finisher D373/D374
Fin2 3000-Sheet Finisher B830
Fin3 Japan Only. Please ignore.
Fin4 Ring Binder D392
4
167