Fusing Exit Sensor, Accordion Jam Sensor - Ricoh V-C3 D081 Field Service Manual

4. Replacement and Adjustments
• Before setting the fusing unit in the drawer, make sure that the lock/release lever is in the open position.
• After reinstalling the fusing unit, make sure that the lock/release lever is in the locked position and
finger tight before you close the drawer unit.
• If the lock/release lever is not locked, this could cause a problem if power is turned off accidentally
during copying. If this occurs, the drawer unit can be pulled out, but the user may not be able to push
it back in because the fusing unit is still pressed up by the cam. Do the following to reset the cam.
1. Remove the fusing unit from the drawer unit.
2. Close the drawer, then close the front door.
3. Turn the main power on. The cam moves down.
4. Open the drawer and put the fusing unit back in the machine.
4
5. Confirm that the lock/release lever is in the locked position.
6. Close the drawer unit and front door.

Fusing Exit Sensor, Accordion Jam Sensor

1. Remove:
• Fusing unit (
2. Remove:
[A] Sensor bracket ( x2)
[B] Fusing exit sensor (
[C] Accordion jam sensor (
404
p.402)
x1)
x1)