Ricoh V-C3 D081 Field Service Manual page 837

This SP sets the page interval for execution of process control at job end for color printing.
[0 to 5000/250/1]
3 Pg Cnt:B&W Mode
4 Pg CntColor Mode
3552 Set Procon:Interrupt
These SP codes settings determine whether a long print job is interrupted temporarily in order
to execute process control. (Normally long print jobs are not interrupted for process control
unless these settings are changed.)
1 B/W Mode
Sets the page interval to trigger process control during a long monochrome print job.
[0 to 2000/0/ 1 sheet]
2 Color Mode
Sets the page interval to trigger process control during a long color print job.
[0 to 1000/0/ 1 sheet]
3 Pg Cnt:B&W Mode
4 Pg Cnt:Color Mode
3554 Init ProCon Set
The machine determines the amount of time elapsed since the drum motors stopped (print
end, process control end, etc.) and the amount of change in the temperature and humidity
since the last cold start.
In order to determine if initial processing control self-check executes, the machine compares:
• The time the drum stop last stopped (SP3556-1 to 5: Last Print Date/Time)
• The temperature and humidity when the drum last stopped (SP2901-5 to 8)
If the difference between temperature and humidity is higher than the temperature/humidity
threshold for a cold start, then initial process control self-check executes again.
1 Non-use Time Setting
Displays the current page interval counts for the execution
of process control execution for both monochrome and color
printing.
[0 to 5000/0/1]
Displays the current page counts that will interrupt long
monochrome or color print jobs in order to execute process
control.
[0 to 5000/ 0/ 1 sheet]
Group 3000
4
259