Ricoh V-C3 D081 Field Service Manual page 264

2. Installation
• The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not install the
components in the box.
2. If the surfaces of the tapes do not show "VOID", remove them from the corners of the box.
3. You can see the "VOID" marks [2] when you remove each seal. In this condition, they cannot be
attached to the box again.
2
Installation Procedure
1. Remove the slot cover [A] ( x 1).
2. Insert the SD card [B] into the upper slot.
3. Turn on the main power switch.
4. Enter the SP mode.
5. Select SP5878-002 (Option Setup> Encryption Option), and then touch [Execute].
6. Turn off the main power switch.
7. Remove the SD card.
8. Attach the slot cover [A] ( x 1).
9. Switch the machine on.
• Tell the customer that it takes about 6 hours 30 minutes to perform the HDD encryption function.
(The D014/D015 required only about 3 hours.)
262