Ricoh V-C3 D081 Field Service Manual page 676

3. Appendix: Service Call Conditions
SC455 D
3
SC460 D
SC465 C
SC466 C
SC467 C
SC468 C
SC472 C
98
PTR motor error
The lock signal from the paper transfer motor was not detected within 1 sec. after the
motor switched on.
• Motor disconnected
• PTR shaft locked, needs cleaning, blocked by obstruction
• Drive shaft of the ITB locked and overloaded, needs cleaning, or blocked by
obstruction
• DRB disconnected, defective
Separation power pack output error
This SC is issued if the VBCU detects a short in the transfer power pack.
• Damaged insulation on the high-voltage supply cable (replace cable)
• Damaged insulation around the transfer power pack
Image Transfer Roller End: K
Image Transfer Roller End: M
Image Transfer Roller End: C
Image Transfer Roller End: Y
The machine detected an abnormal reading of the resistance of the transfer roller
because it is near the end of its service life.
• Check the connections between the transfer roller power pack the roller
• Replace image transfer roller
• Image transfer power pack defective
ITB Bias Roller End
The machine detected an abnormal reading of the resistance of the ITB bias roller
because it is near the end of its service life.
• Check the connections between the transfer power pack
• Replace image transfer roller
• Transfer power pack defective