Power Supply - Ricoh V-C3 D081 Field Service Manual

8. Put the finisher on a strong and level surface. The front and rear of the machine must be less than 5
mm (0.2") away from level.
9. Do not put the finisher where there could be strong vibrations.
10. Do not connect the finisher to a power supply shared with other electrical devices.
11. The machine generates a strong electromagnetic field. This can cause interference with radio or
television reception.
Machine Level
1. Front to rear: Less than 5 mm (0.2") away from level
2. Right to left: Less than 5 mm (0.2") away from level
The finisher legs can be turned to adjust them up or down to make the machine level.
Minimum Space Requirements
The minimum clearances at the front and back are the same as the host machine.

Power Supply

Input voltage level
• The finisher must have an independent power source. Avoid multi-wiring.
• The finisher must be properly grounded at the power source.
100 to 240V 50/60 Hz
NA: 120V 50/60 Hz 5A
EU: 220 to 240V 50/60 Hz 3A
Ring Binder (D392) Installation
2
169