Ricoh V-C3 D081 Field Service Manual page 500

4. Replacement and Adjustments
• Removing the ITB unit is recommended to prevent the tip of the drum motor shaft from scratching
the surface of the ITB when the motor is removed or reinstalled.
5. Pull out the motor [A] with its drive shaft.
4
• In order to remove the K PCU motor [A], you must first loosen the duct [B].
• Before removing the Y PCU motor [C], you must first loosen the fan [D].
Drum Motor Reinstallation
1. Push the shaft into the machine and set the motor [A], so that it is straight.
2. Attach the screws and tighten them only halfway. This leaves the motor shaft loose so it can float
slightly.
3. Check the front of the machine and confirm that the shaft [B] is straight.
498