Ricoh V-C3 D081 Field Service Manual page 705

Stacking Roller Drag Motor Error (D373/D374, B830)
The stacking roller drag motor did not turn on.
SC754 B
• Motor harness loose, broken, defective
• Motor defective
• Finisher control board defective
Shift Motor Error: 3K Finisher (D373/D374, B830)
The shift tray half-turn sensors:
SC755 B
Failed twice to detect the shift tray at the home position at the specified time.
-or-
Failed twice to detect that the shift tray had left the home position.
If the motor is operating
• Half-turn sensor 1, 2 harnesses loose, broken, defective
• One of the half-turn sensors defective
If the motor is not operating:
• Motor blocked by an obstruction
• Motor harness loose, broken, defective
• Motor defective
• Finisher main board defective
Finisher punch motor error (D373/D374, B830)
The punch HP sensor is not activated within the specified time after the punch motor
turned on. The 1st detection failure causes a jam error, and the 2nd failure causes this
SC code.
SC760 D
• Punch HP sensor disconnected, defective
• Punch motor disconnected, defective
• Punch motor overload due to obstruction
Service Call Tables
3
127