Moving Applications To One Sd Card - Ricoh V-C3 D081 Field Service Manual

DIMMs
1. Hold the ROM DIMM as shown above. The edge connector [A] points toward the slot and the notch
[B] is in the top right corner.
2. Insert the edge connector [C] in the slot at a 30-degree angle from the surface of the board. If the
angle is too low, the upper contact could bend.
3. Carefully move the outer edge of the ROM DIMM up and down slightly until it goes into the connector
then carefully push it down unit it is level with the controller board.
• If the upper contact is pushed in with force and bends, the connection will be defective and the
machine will not operate.
SD cards
SD cards are held in position by a small spring-lock mechanism.
1. To install an SD card, push it into the slot until it stops, then release it.
2. To remove an SD card, push the SD card in carefully to release it, and then remove it from the slot.

Moving Applications to One SD Card

Overview
There are only two SD card slots:
• Slot 2 (upper slot). Insert the application card in this slot.
MFP Controller Options
2
249