Ricoh V-C3 D081 Field Service Manual page 188

2. Installation
Preparing the Finisher
2
1. Remove the cover [A] of the relay connector.
2. Loosen the screw of the bracket [B] ( x 1) then remove the bracket.
3. Remove the guide plate [C]. (You will attach this guide plate to the cover interposer. Do not discard
it.)
• If you will install the cover interposer tray on a D373/D374 finisher that was installed on the
machine before this time, remove the sponge strip from the finisher. Keep this strip because you
must attach it later to the interposer tray.
186