Ricoh V-C3 D081 Field Service Manual page 711

Entrance JG Motor
The entrance junction gate HP sensor did not detect the entrance junction gate
at (or out of) its home position. The 1st occurrence causes a jam, and the 2nd
occurrence causes this SC code.
SC778-4 D
1st Stopper Motor Error
The 1st stopper HP sensor did not detect the 1st stopper in (or out of) its home
position within the prescribed time. The 1st occurrence causes a jam, and the 2nd
occurrence causes this SC code.
SC779 B
• 1st stopper HP sensor dirty
• Sensor harness or connector loose, broken, defective
• 1st stopper motor harness or connector loose, broken, defective
• Sensor defective
• Motor or motor drive board defective
Z-Fold Feed Motor Error Japan Only
The feed motor that drives the feed rollers and exit rollers in the Z-fold unit is not
operating. The 1st alert signals a jam, the 2nd alert triggers this SC.
SC780 B
• Motor harness loose, broken, defective
• Motor blocked by an obstruction
• Motor defective
• Entrance JG HP sensor dirty
• Sensor harness or connector loose, broken, defective
• Entrance JG motor harness or connector loose, broken, defective
• Sensor defective
• Motor or motor drive board defective
Service Call Tables
Multi Folder (D454)
Multi Folder (D454)
133
3