Ricoh V-C3 D081 Field Service Manual page 276

2. Installation
1. Remove
• Rear upper cover
• Controller box cover
2. Touch a metal surface to discharge any static electricity from your hands.
3. Push the connector on the underside of the Copy Data Security PCB [A] into its slot on the IPU.
2
4. Carefully fasten the Copy Data Security PCB to the IPU ( x2).
• Do not touch the surface of any other board with the tip of the screwdriver.
User Tool Setting
1. Plug in and turn on the main power switch.
2. Go into the User Tools mode, and select System Settings > Administrator Tools > Data Security for
Copying > "On".
3. Exit the User Tools.
4. Check the operation.
• The machine will issue an SC165 error if the machine is powered on with the ICIB-1 removed
and the "Data Security for Copying" feature is set to "ON".
• When you remove this option from the machine, first set the setting to "OFF" with the user tool
before removing this board. If you forget to do this, "Data Security for Copying" feature cannot
appear in the user tool settings. And then SC165 will appear every time the machine is switched
on, and the machine cannot be used.
5. Make sure that the machine can recognize the option (
section).
274
"Check All Connections" at the end of this