Centering Paper In The Paper Path - Ricoh V-C3 D081 Field Service Manual

2. Installation
4. Use the sharp point of a pen [B] or similar tool to push in the breaker switch until it snaps to the off
position. (You should see "0".)
5. If the breaker does not snap to the off position:
• Check that the power cord is correctly connected to the finisher and power supply.
• Push the breaker switch again to see if it snaps to the off position.
2
• If the breaker switch does not snap to the off position, it must be replaced.
6. Be sure to reset the breaker switch to the on (-) position.

Centering Paper in the Paper Path

At installation you must confirm that the paper is exiting the ring binder correctly and do the necessary
correction if required. There are two checks:
• Side-to-side registration check. The paper should be centered in the paper path.
• Skew check. The paper should feed straight out of the ring binder.
Checking and Correcting Side-to-Side Registration
Checking Side-to-Side Registration
Do this check to confirm that the paper is centered in the paper path.
1. Make sure that the I/F cable of the ring binder unit is connected.
2. If the finisher is connected to the left side of the ring binder, disconnect it and pull it away from the left
side of the ring binder.
3. Execute a run by feeding paper (A4 or LT) from Tray 2 of the host machine (punching only, no ring
binding).
4. During the run, each sheet of paper briefly protrudes about 5 to 10 mm before it switches back into
the ring binder and feeds to the punch unit, as shown above.
176