Ricoh V-C3 D081 Field Service Manual page 207

5. Slide the punch unit [A] on its rails into the finisher. Make sure that the pins engage correctly at the
front and rear.
6. Connect and attach the punch unit [B] (
• The cables [C] are coiled and attached to the PCB.
• Attach connectors to CN601 and CN602.
7. Attach the slide drive unit [A] to the finisher and connect it to the punch unit ( x 2,
the slide drive unit at (1) when you attach screw (2).
8. Make sure that the punch unit moves freely and is not blocked by the screws.
x 2, x 1).
Punch Unit (B702-17, -27, -28)
x 1). Push in
2
205