Ricoh V-C3 D081 Field Service Manual page 74

2. Installation
• Make sure that you have removed all the seal strips (you should have four strips, one for each
bottle).
11. Gently tap the sides of each bottle with a finger to make sure that the developer flows freely.
2
12. Check once again to make sure that the lever is down.
• The lever must be down. If you attempt to drain the developer bottles with SP3814 with the lever
up, the machine will return "Failed".
13. Close the front door.
• The door must be closed before you switch the machine on.
14. Turn the machine power on and wait for the machine to beep twice.
• The beeps indicate that the fusing unit is ready. Do not proceed until after you hear the two beeps.
If you attempt to drain the developer bottles with SP3814 before you hear the two beeps, the
machine will return "Failed".
15. Enter the SP mode and do the following SPs:
• SP3814-1. Fills all of the PCU units with developer from the attached bottles. It takes about 3
minutes. Touch [Exit] when "Completed" appears on the display.
• SP3815. Confirms that SP3814-1 executed correctly. If SP3814-1 executed correctly, you will
see "1111" (K M C Y).
Display
1
4
72
What It Means
Succeeded
Factory default value (SP3814 has not been used yet)