Ricoh V-C3 D081 Field Service Manual page 263

• These settings must be set up by the customer before the encryption option can be installed.
2. Confirm that "Admin. Authentication" is on:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication Management">
"Admin. Authentication"> "On"
If this setting is "Off" tell the customer that this setting must be "On" before you can do the installation
procedure.
3. Confirm that "Administrator Tools" is selected and enabled:
[User Tools]> "System Settings"> "Administrator Tools"> "Administrator Authentication Management">
"Available Settings
• "Available Settings" is not displayed until "Admin. Authentication" is switch on.
If this setting is not selected tell the customer that this setting must be selected before you can do the
installation procedure.
Seal Check and Removal
• You must check the box seals to make sure that they were not removed after the items were sealed in
the box at the factory before you do the installation.
1. Check the box seals [1] on each corner of the box.
• Make sure that a tape is attached to each corner.
MFP Controller Options
2
261