Ricoh V-C3 D081 Field Service Manual page 234

2. Installation
2
14. Connect the PCB harness connector [A] to CN135 of the finisher PCB and to CN600 of the punch
unit PCB.
15. Connect the harness [B] to CN136 of the finisher PCB.
16. Connect the single end of the hopper full sensor connector cable [C] to the hopper full sensor on the
arm ( x 1,
• No special DIP switch settings are required for this punch unit. A signal from the punch identifies
itself by sending a signal to the copier.
232
x 2).