Ricoh V-C3 D081 Field Service Manual page 961

22 Bottom Plate Position Sensor
ADF Output Check
Turns on the ADF electrical components individually for testing.
1. Open SP mode SP6008.
6008
2. Select the SP number that corresponds to the component you wish to check.
3. Press [On] then press [Off ]to test the selected item. You cannot exit and close this display
until you click Off to switch off the output check currently executing.
001 ADF Feed M: Fwd
002 ADF Feed M: Rev
003 ADF Trans M: Fwd
004 ADF Exit M: Fwd
009 ADF Pickup M: Fwd
010 ADF BotPlt M: Fwd/Rev
6009 ADF Free Run
This SP does an ADF free run in duplex original mode.
1 Simplex
2 Dupx
6016 ADF OrgSizePrior
ADF Original Size Detection Priority. Allows selection of alternate settings for automatic original
size detection.
(7) 0000 0000 (1)
6017 ADF Mag Adj
ADF Magnification Adjustment
Not Correct Position
Group 6000
Correct Position
383
4