D-Link DGS-510 Reference Manual page 447

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Default
None.
Command Mode
Global Configuration Mode.
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command can be used in the global configuration mode and interface configuration mode.
If the command is configured in the global configuration mode, the maximum user number limits the
user number of the entire system.
If the command is configured in the interface configuration mode, the maximum user number is set for
the interface.
The maximum users being limited include 802.1X, MAC-based Access Control, WAC, and JWAC
users.
In addition, the command has the following limitation:
 If the new maximum is less than the current number of users, the command will be rejected and
the error message will be prompted.
Example
This example shows how to set the maximum authenticated users for system.
Switch# configure terminal
Switch(config)# authentication max users 256
Switch(config)#
50-12 authentication mac-move deny
This command is used to disable MAC move on the Switch. Use the no form of this command to
revert to the default setting.
authentication mac-move deny
no authentication mac-move deny
Parameters
None.
Default
By default, this option is permitted.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command control whether to allow authenticated hosts to do roaming across different switch
ports. This command only controls whether a host which is authenticated at a port set to multi-auth
mode is allowed to move to another port.
444