D-Link DGS-510 Reference Manual page 35

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display the global configuration or interface configuration. If the
configuration command is entered without parameters, the global configuration will be displayed.
Otherwise, the configuration on the specified interface will be displayed.
Example
This example shows how to display the dot1X global configuration.
Switch# show dot1x
802.1X
Trap State
Switch#
This example shows how to display the dot1X configuration on Ethernet port 1/0/1.
Switch# show dot1x interface eth1/0/1
Interface
PAE
Control Direction
Port Control
Tx Period
Supp Timeout
Server Timeout
Max-req
Forward PDU
Switch#
3-13 show dot1x diagnostics
This command is used to display IEEE 802.1X diagnostics. If no interface is specified, information
about all interfaces will be displayed.
show dot1x diagnostics [interface INTERFACE-ID [, | -]]
(Optional) Specifies to display the dot1x configuration on the
specified interface or range of interfaces. If not specified, the global
configuration will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
: Enabled
: Enabled
: eth1/0/1
: Authenticator
: Both
: Auto
: 30 sec
: 30 sec
: 30 sec
: 2 times
: Disabled
32