D-Link DGS-510 Reference Manual page 350

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The JWAC interface configuration command allows hosts connected to the port to do authentication
via the Web browser.
Example
This example shows how to enable the JWAC function on interface eth1/0/1.
Switch# configure terminal
Switch(config)# jwac virtual-ip ipv4 1.1.1.1
Switch(config)# jwac virtual-ip url www.website1.com
Switch(config)# jwac success redirect-path http://www.website2.com
Switch(config)# jwac redirect destination jwac-login-page
Switch(config)# jwac system-auth-control
Switch(config)# interface eth1/0/1
Switch(config-if)# jwac enable
Switch(config-if)#
40-3 jwac forcible-logout
This command is used to enable the JWAC forcible logout function. Use the no form of this command
to disable the JWAC forcible logout function.
jwac forcible-logout
no jwac forcible-logout
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the forcible logout feature is enabled, a ping packet from an authenticated host to the JWAC
switch with a TTL of 1 will be regarded as a logout request and the host will be moved back to
unauthenticated state.
347