Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. When the function proxy reporting is
enabled, the received multiple IGMP report or leave packets for a specific (S, G) will be integrated into
one report before being sent to the router port. Proxy reporting source IP will be used as source IP of
the report, Zero IP address will be used when the proxy reporting source IP is not set.
Example
This example shows how to enable IGMP snooping proxy-reporting on VLAN 1 and configure the
proxy-reporting message source IP to be 1.2.2.2.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-if)# ip igmp snooping proxy-reporting source 1.2.2.2
Switch(config-if)#
33-7
ip igmp snooping querier
This command is used to enable the capability of the entity as an IGMP querier. Use the no form of
this command to disable the querier function.
ip igmp snooping querier
no ip igmp snooping querier
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. If the system can play the querier
role, the entity will listen for IGMP query packets sent by other devices. If IGMP query message is
received, the device with lower value of IP address becomes the querier.
Example
This example shows how to enable the IGMP snooping querier on VLAN 1.
Switch# configure terminal
Switch(config)# vlan 1
Switch(config-vlan)# ip igmp snooping querier
Switch(config-vlan)#
33-8
ip igmp snooping query-interval
This command is used to configure the interval at which the IGMP snooping querier sends IGMP
general query messages periodically. Use the no form of this command to revert to the default setting.
289
Advertisement
Table of Contents
