D-Link DGS-510 Reference Manual page 376

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
43-11 lldp run
This command is used to enable the Link Layer Discovery Protocol (LLDP) globally. Use the no form
of this command to revert to the default setting.
lldp run
no lldp run
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to globally enable LLDP and then the Switch can start to transmit LLDP packets
and receive and process the LLDP packets. However, the transmission and receiving of LLDP can be
controlled respectively by the lldp transmit command and the lldp receive command in the interface
configuration mode. LLDP takes effect on a physical interface only when it is enabled both globally
and on the physical interface.
By advertising LLDP packets, the Switch announces the information to its neighbor through physical
interfaces. On the other hand, the Switch will learn the connectivity and management information from
the LLDP packets advertised from the neighbor(s).
Example
This example shows how to enable LLDP.
Switch# configure terminal
Switch(config)# lldp run
Switch(config)#
43-12 lldp forward
This command is used to enable the LLDP forwarding state. Use the no form of this command to
revert to the default settings.
lldp forward
no lldp forward
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
373