D-Link DGS-510 Reference Manual page 487

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the PD alive check settings on the specified ports. When no optional
parameter is specified, information of all PoE ports will be displayed.
Example
This example shows how to display the PD alive check settings on interface eth1/0/1-2.
Switch#show poe pd alive interface eth1/0/1-2
Port ID: eth1/0/1
---------------------------------------------
PD Alive State
PD IP Address
Poll Interval
Retry Count
Waiting Time
Action
Port ID: eth1/0/2
---------------------------------------------
PD Alive State
PD IP Address
Poll Interval
Retry Count
Waiting Time
Action
Switch#
Specifies the interface ID to display.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space before and after the
comma.
(Optional) Specifies a range of interfaces. No space before and
after the hyphen.
: Enabled
: 0.0.0.0
: 30
: 2
: 90
: both
: Enabled
: 192.168.1.150
: 60
: 4
: 120
: reset
484