D-Link DGS-510 Reference Manual page 736

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
The table below shows the definition of Tag field (different with RFC 2868):
Tag field value
0x01
0x02
Others
(0x00, 0x03 ~ 0x1F,>0x1F)
NOTE: A tag field of greater than 0x1F is interpreted as the first octet of the following field.
If the user has configured the VLAN attribute of the RADIUS server (for example, VID 3) and the
802.1X, MAC-based Access Control, JWAC, or WAC authentication is successful, the port will be
assigned to VLAN 3. However, if the user does not configure the VLAN attributes, when the port is not
guest VLAN member, it will be kept in its current authentication VLAN, and when the port is guest
VLAN member, it will be assigned to its original VLAN.
To assign the ACL by the RADIUS server, the proper parameters should be configured on the
RADIUS server. The table below shows the parameters for an ACL.
The parameters of the Vendor-Specific Attribute are:
RADIUS Tunnel Attribute
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the ACL attribute of the RADIUS server (for example, ACL script: ip access-
list a1;permit host 10.90.90.100;exit; mac access-list extended m1;permit host 00-00-00-01-90-10 any;
exit;), and the 802.1X, MAC-based Access Control, JWAC, or WAC is successful, the device will
assign the ACL script according to the RADIUS server. The enter Access-List Configuration Mode
and exit Access-List Configuration Mode must be a pair, otherwise the ACP script will be reject. For
more information about the ACL module, please refer to Access Control List (ACL) Commands
chapter.
String field format
VLAN name (ASCII)
VLAN ID (ASCII)
When the switch receives the VLAN setting string, it will think it is
the VLAN ID first. In other words, the switch will check all existing
VLAN IDs and check if there is one matched. If the switch can find
one matched, it will move to that VLAN. If the switch cannot find the
matched VLAN ID, it will think the VLAN setting string as a "VLAN
Name". Then it will check that it can find out a matched VLAN
Name.
Description
Defines the vendor.
Defines the attribute.
Used to assign the ACL
script. The format is based
on Access Control List
(ACL) Commands.
733
Value
171 (DLINK)
14 (for ACL script)
ACL Script
For example:
ip access-list a1;permit
host 10.90.90.100;exit;
mac access-list
extended m1;permit
host 00-00-00-01-90-10
any; exit;
Usage
Required
Required
Required