D-Link DGS-510 Reference Manual page 385

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Enabled Protocol Identity
43-22 show lldp local interface
This command is used to display physical interface information that will be carried in the LLDP TLVs
and sent to neighbor devices.
show lldp local interface INTERFACE-ID [, | -] [brief | detail]
Parameters
INTERFACE-ID
,
-
brief
detail
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command displays each physical interface's local LLDP information currently available for
populating outbound LLDP advertisements.
Example
This example shows how to display the local information of port 1 in detailed mode.
sending VLAN Name TLVs. The VLAN list includes the configured
enabled VLANs. If there is no configured VLAN for the VLAN Name
TLV, the string is "(None)".
Displays the enabled protocol string for protocol identity TLVs. If
there is no enabled protocol for protocol identity TLVs, the string is
"(None)".
Specifies the interface's ID. Valid interfaces are physical interfaces.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
(Optional) Specifies to display the information in brief mode.
(Optional) Specifies to display the information in detailed mode. If
neither brief nor detail is specified, display the information in the
normal mode.
382