Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
-
address
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the current port security settings.
Example
This example shows how to display the port security settings of interfaces eth1/0/1 to eth1/0/3.
Switch# show port-security interface eth1/0/1-3
D:Delete-on-Timeout
Interface
No.
------------ ----- ----- -------- -------------------- -- -------- -----------
eth1/0/1
eth1/0/2
eth1/0/3
Switch#
52-3
snmp-server enable traps port-security
This command is used to enable sending SNMP notifications for port security address violation. Use
the no form of this command to disable sending SNMP notifications.
snmp-server enable traps port-security [trap-rate TRAP-RATE]
no snmp-server enable traps port-security [trap-rate]
Parameters
trap-rate TRAP-RATE
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
Specifies to display all the secure MAC addresses, including both
configured and learned entries.
P:Permanent
Max
Curr
Violation
No.
No.
Act.
5
2
Restrict
10
10
Shutdown
10
0
Shutdown
(Optional) Specifies the number of traps per second. The range is
from 0 to 1000. The default value ("0") indicates an SNMP trap to be
generated for every security violation.
Violation
Security Admin
Count
0
0
0
464
Current
Mode
State
State
D
Enabled
Forwarding
D
Enabled
Err-disabled
P
Disabled -
Advertisement
Table of Contents
