D-Link DGS-510 Reference Manual page 293

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
ip igmp snooping query-interval SECONDS
no ip igmp snooping query-interval
Parameters
SECONDS
Default
By default, this value is 125 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration. The query interval is the interval
between General Queries sent by the Querier. By varying the query interval, an administrator may
tune the number of IGMP messages on the network; larger values cause IGMP Queries to be sent
less often.
Example
This example shows how to configure the IGMP snooping query interval to 300 seconds on VLAN
1000.
Switch# configure terminal
Switch(config)# vlan 1000
Switch(config-vlan)# ip igmp snooping query-interval 300
Switch(config-vlan)#
33-9 ip igmp snooping query-max-response-time
This command is used to configure the maximum response time advertised in IGMP snooping queries.
Use the no form of this command to revert to the default setting.
ip igmp snooping query-max-response-time SECONDS
no ip igmp snooping query-max-response-time
Parameters
SECONDS
Default
By default, this value is 10 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Specifies to configure the interval at which the designated router
sends IGMP general-query messages. The range is 1 to 31744.
Specifies to set the maximum response time, in seconds, advertised
in IGMP snooping queries. The range is 1 to 25.
290