Stacking Commands - D-Link DGS-510 Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide

66. Stacking Commands

66-1 stack
This command is used to enable the daisy-chain stacking function and use the no stack command to
disable the daisy-chain stacking function.
stack
no stack
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
The ports on a stackable switch unit, used to chain with other switch units, can either work as stacking
ports or work as ordinary Ethernet ports based on the setting of the stack command. The stack
command setting of a switch unit must be enabled before the switch unit can be chained with other
switch units. The setting will be saved in the individual switch unit if the user saves the configuration.
Example
This example shows how to enable stacking mode.
Switch# stack
WARNING: The command does not take effect until the next reboot.
Switch#
66-2 stack renumber
This command is used to manually assign a unit ID to a switch unit. Use the no form of this command
to set the unit ID of the Switch to auto-assigned.
stack CURRENT-UNIT-ID renumber NEW-UNIT-ID
no stack CURRENT-UNIT-ID renumber
Parameters
CURRENT-UNIT-ID
NEW-UNIT-ID
Default
The unit ID is assigned automatically.
Specifies the switch unit being configured.
Specifies the new unit ID assigned to the Switch.
613