D-Link DGS-510 Reference Manual page 379

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
SECONDS
Default
By default, this value is 2 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The LLDP transmission interval must be greater than or equal to four times of the transmission delay
timer.
Example
This example shows how to configure the transmission delay timer to 8 seconds.
Switch# configure terminal
Switch(config)# lldp tx-delay 8
Switch(config)#
43-16 lldp tx-interval
This command is used to configure the LLDPDUs transmission interval on the Switch. Use the no
form of this command to revert to the default setting.
lldp tx-interval SECONDS
no lldp tx-interval
Parameters
SECONDS
Default
By default, this value is 30 seconds.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This interval controls the rate at which LLDP packets are sent.
Example
This example shows how to configure that LLDP updates are sent every 50 seconds.
Specifies the delay value for sending successive LLDPDUs on an
interface. The valid values are from 1 to 8192 seconds and should
not be greater than one-fourth of the transmission interval timer.
Specifies the interval between consecutive transmissions of LLDP
advertisements on each physical interface. The range is from 5 to
32768 seconds.
376