D-Link DGS-510 Reference Manual page 442

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# authentication timer inactivity 240
Switch(config-if)#
50-5 authentication timer reauthentication
This command is used to configure the timer to re-authenticate a session. Use the no form of this
command to revert to the default setting.
authentication timer reauthentication {SECONDS}
no authentication timer reauthentication
Parameters
SECONDS
Default
By default, this value is 3600 seconds.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to configure the re-authentication timer.
Example
This example shows how to configure the re-authentication timer value to 200 for eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# authentication timer reauthentication 200
Switch(config-if)#
50-6 authentication timer restart
This command is used to configure the timer to restart the authentication after the last failed
authentication. Use the no form of this command to revert to the default setting.
authentication timer restart SECONDS
no authentication timer restart
Parameters
SECONDS
Specifies the timer to re-authenticate a session. The range is from 1
to 65535.
Specifies the authentication restart timer value. The range is from 1
to 65535
439