D-Link DGS-510 Reference Manual page 95

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the default authentication method list for 802.1X authentication.
Initially, the default method list is not configured. The authentication of 802.1X requests will be
performed based on the local database.
Example
This example shows how to set the default methods list for authenticating dot1X users.
Switch#configure terminal
Switch(config)# aaa authentication dot1x default group radius
Switch(config)#
8-7 aaa authentication jwac
This command is used to configure the default method list used for JWAC authentication. Use the no
form of this command to remove the default method list.
aaa authentication jwac default METHOD1 [METHOD2...]
no aaa authentication jwac default
Parameters
METHOD1 [METHOD2...]
Default
No AAA authentication method is configured.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to configure the default authentication method list for JWAC authentication. Initially,
the default method list is not configured. The authentication of JWAC requests will be performed
based on the local database.
Example
This example shows how to set the default methods list for authenticating dot1X users.
Specifies the list of methods that the authentication algorithm tries
in the given sequence. Enter at least one method or enter up to four
methods. The following are keywords that can be used to specify a
method.
local – Specifies to use the local database for authentication.
group radius – Specifies to use the servers defined by the RADIUS
server host command.
group GROUP-NAME – Specifies to use the server groups defined
by the AAA group server.
none - Normally, the method is listed as the last method. The user
will pass authentication if it is not denied by previous method
authentication.
92