D-Link DGS-510 Reference Manual page 37

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
show dot1x statistics [interface INTERFACE-ID [, | -]]
Parameters
interface INTERFACE-ID
,
-
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command can be used to display 802.1X statistics. Using this command without parameters will
display information about all interfaces. Otherwise, the statistics on the specified interface will be
displayed.
Example
This example shows how to display dot1X statistics on Ethernet port 1/0/1.
Switch# show dot1x statistics interface eth1/0/1
eth1/0/1 dot1x statistics information:
EAPOL Frames RX
EAPOL Frames TX
EAPOL-Start Frames RX
EAPOL-Req/Id Frames TX
EAPOL-Logoff Frames RX
EAPOL-Req Frames TX
EAPOL-Resp/Id Frames RX
EAPOL-Resp Frames RX
Invalid EAPOL Frames RX
EAP-Length Error Frames RX
Last EAPOL Frame Version
Last EAPOL Frame Source
Switch#
3-15 show dot1x session-statistics
This command is used to display IEEE 802.1X session statistics. If no interface specified, information
about all interfaces will be displayed.
show dot1x session-statistics [interface INTERFACE-ID [, | -]]
(Optional) Specifies to display the dot1x diagnostics on the
specified interface or range of interfaces. If not specified,
information about all interfaces will be displayed.
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and
after the comma.
(Optional) Specifies a range of interfaces. No space is allowed
before and after the hyphen.
: 1
: 4
: 0
: 6
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 00-10-28-00-19-78
34