D-Link DGS-510 Reference Manual page 278

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
Administrators can enable the global GVRP state and individual port's GVRP state to start GVRP on
the port.
Example
This example shows how to enable the GVRP protocol global state.
Switch# configure terminal
Switch(config)# gvrp global
Switch(config)#
31-3 gvrp enable
This command is used to enable the GVRP function on a port. Use the no form of this command to
disable the GVRP function on a port.
gvrp enable
no gvrp enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for both physical ports and port-channel interface configuration. This
command only takes effect for hybrid mode and trunk mode.
Example
This example shows how to enable the GVRP function on interface eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# gvrp enable
Switch(config-if)#
31-4 gvrp advertise
This command is used to specify the VLAN that are allowed to be advertised by the GVRP protocol.
Use the no form of this command to disable the VLAN advertisement function.
gvrp advertise {all | [add | remove] VLAN-ID [, | -]}
no gvrp advertise
275