D-Link DGS-510 Reference Manual page 448

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
If a station is allowed to move, there are two situations. It may either need to be re-authenticated or
directly moved to the new port without re-authentication based on the following rule. If the new port
has the same authentication configuration as the original port, then re-authentication is not needed.
The host will inherit the same authorization attributes with new port. The authenticated host can do
roaming from port 1 to port 2, and inherit the authorization attributes without re-authentication. If the
new port has the different authentication configuration as the original port, then re-authentication is
needed. The authenticated host on port 1 can move and re-authenticated by port 2. If the new port
has no authentication method enabled, then the station is directly moved to the new port. The session
with the original port is removed. The authenticated host on port 1 can be moved to port 2.
If MAC move is disabled and an authenticated host moves to another port, then this is treated as a
violation error.
Example
This example shows how to enable MAC move on the Switch.
Switch# configure terminal
Switch(config)# authentication mac-move deny
Switch(config)#
50-13 authorization disable
This command is used to disable the acceptance of the authorized configuration. Use the no form to
enable the acceptance of the authorized configuration.
authorization disable
no authorization disable
Parameters
None.
Default
By default, this option is enabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The command is used to enable or disable the acceptance of an authorized configuration. When
authorization is enabled for authentication, the authorized attributes (for example VLAN, 802.1p
default priority, bandwidth, and ACL) assigned by the RADIUS server will be accepted if the
authorization status is enabled. Bandwidth and ACL are assigned on a per-port basis. If in the multi-
auth mode, VLAN and 802.1p are assigned on a per-host basis. Otherwise, Bandwidth and ACL are
assigned on a per-port basis.
Example
This example shows how to enable the authorization status.
Switch# configure terminal
Switch(config)# no authorization disable
Switch(config)#
445