D-Link DGS-510 Reference Manual page 331

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch#traceroute 211.21.180.1
10 ms
30 ms
30 ms
<10 ms
<10 ms
Trace complete.
Switch#
This example shows how to traceroute the host with IPv6 address
2001:238:f8a:77:7c10:41c0:6ddd:ecab.
Switch#traceroute 2001:238:f8a:77:7c10:41c0:6ddd:ecab
10 ms
Trace complete.
Switch#
36-4 ip helper-address
This command is used to add a target address for forwarding of UDP broadcast packets. Use the no
form of this command to remove the specified forwarding target address.
ip helper-address IP-ADDRESS
no ip helper-address [IP-ADDRESS]
Parameters
IP-ADDRESS
Default
None.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is only available for VLAN interface configuration.
Use the command together with the ip forward-protocol command to control the forwarding of UDP
broadcast packets.
This command takes effect only when the received interface has an IP address assigned.
The system only forwards the packet that satisfies the following restrictions:
 Destination MAC address must be broadcast address.
10.1.1.254
192.168.249.134
192.168.249.134
192.168.5.230
211.21.180.1
1001:238:f8a:77:7c10:41c0:6ddd:ecab
Specifies the forwarding target IP address. More than one helper
address can be specified for an interface.
328