Table of Contents
Advertisement
DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
dot3StatsSingleColFrames
dot3StatsMultiColFrames
dot3StatsSQETestErrors
dot3StatsDeferredTransmisions
dot3StatsLateCollisions
dot3StatsExcessiveCollisions
dot3StatsInternalMacTransmitErr
ors
dot3StatsCarrierSenseErrors
dot3StatsFrameTooLongs
dot3StatsInternalMacReceiveErro
rs
34-6
show interfaces
This command is used to display the interface information.
show interfaces [INTERFACE-ID [- | ,]]
Parameters
INTERFACE-ID
Transmit Single Collision Frame Counter.
10/100 mode only - incremented for each frame transmitted
which experienced exactly one collision during transmission.
Transmit Multiple Collision Frame Counter.
10/100 mode only - incremented for each frame successfully
transmitted for which transmission is inhibited by more than
one collision.
SQET Test Error Counter. Incremented for times that the SQE
TEST ERROR message is generated by the PLS sublayer for
a particular interface. The SQE TEST ERROR message is
defined in section 7.2.2.2.4 of ANSI/IEEE 802.3-1985 and its
generation is described in section 7.2.4.6 of the same
document.
Note: This counter does not increment at speeds greater than
10 Mb/s, or in full-duplex mode.
Transmit Single Deferral Frame Counter.
10/100 mode only - incremented for each frame which was
deferred on its first transmission attempt and did not
experience any subsequence collisions during transmission.
Transmit Late Collision Frame Counter.
10/100 mode only - incremented for each frame transmitted
which experienced a late collision during a transmission
attempt.
Transmit Excessive Collision Frame Counter.
10/100 mode only - incremented for each frame transmitted
for which transmission fails due to excessive collisions.
Transmit Internal MAC Error Frame counter. Incremented for
frames for which transmission fails due to an internal MAC
sublayer transmitting error. A frame is only counted if it is not
counted by any of the dot3StatsLateCollisions, the
dot3StatsExcessiveCollisions, and the
dot3StatsCarrierSenseErrors.
False Carrier Counter. Incremented for times that the carrier
sense condition was lost or never asserted when attempting to
transmit a frame.
Receive Frame Too Long Counter. Incremented for each
frame received which exceeds the max-rcv-frame-size.
Receive Internal MAC Error counter. Incremented for frames
for which reception fails due to an internal MAC sublayer
receiving error. A frame is only counted if it is not counted by
the corresponding instance of any of the
dot3StatsFrameTooLongs, the dot3StatsAlignmentErrors, or
the dot3StatsFCSErrors.
(Optional) Specifies that the interface can be a physical port, VLAN,
309
Advertisement
Table of Contents
