D-Link DGS-510 Reference Manual page 535

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
falling-threshold VALUE
FALLING-EVENT-NUMBER
owner STRING
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The RMON alarm facility periodically takes samples of the value of variables and compares them
against the configured threshold.
Example
This example shows how to configure an alarm entry to monitor an interface.
Switch# configure terminal
Switch(config)# rmon alarm 783 1.3.6.1.2.1.2.2.1.12.6 30 delta rising-threshold 20
1 falling-threshold 10 1 owner Name
Switch(config)#
57-4 rmon event
This command is used to configure an event entry. Use the no form of this command to remove an
event entry.
rmon event INDEX [log] [[trap COMMUNITY] [owner NAME] [description STRING]
no rmon event INDEX
Parameters
INDEX
log
trap COMMUNITY
owner NAME
description STRING
Default
None.
Command Mode
Global Configuration Mode.
ringing threshold.
Specifies the falling threshold. The valid range is from 0 to
2147483647.
(Optional) Specifies the index of the event entry that is used to
notify the falling threshold crossing event. The valid range is from 1
to 65535. If not specified, no action is taken while crossing the
falling threshold.
Specifies the owner string. The maximum length is 127.
Specifies the index of the alarm entry. The valid range is from 1 to
65535.
(Optional) Specifies to generate log message for the notification.
(Optional) Specifies to generate SNMP trap messages for the
notification. The maximum length is 127.
(Optional) Specifies the owner string. The maximum length is 127.
(Optional) Specifies a description for the RMON event entry. Enter a
text string with a maximum length of 127 characters.
532