D-Link DGS-510 Reference Manual page 52

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
match ipv6 address {ACL-NAME | ACL-NUMBER}
no match ipv6 address
Parameters
ACL-NAME
ACL-NUMBER
Default
None.
Command Mode
VLAN Access-map Sub-map Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to associate an IPv6 access list with the configured sub-map. One sub-map can
only be associated with one access list (IP access list, IPv6 access list or MAC access list). IPv6 sub-
map just checks IPv6 packets. The later command overwrites the previous setting.
Example
This example shows how to set the match content in the sub-map.
Switch# configure terminal
Switch(config)# vlan access-map vlan-map 20
Switch(config-access-map)# match ipv6 address sp1
Switch(config-access-map)#
4-16 match mac address
This command is used to associate MAC access lists for the configured sub-maps. The no form of
this command removes the match entry.
match mac address {ACL-NAME | ACL-NUMBER}
no match mac address
Parameters
ACL-NAME
ACL-NUMBER
Default
None.
Command Mode
VLAN Access-map Sub-map Configuration Mode.
Specifies the name of the IPv6 ACL access list to be configured.
The name can be up to 32 characters.
Specifies the number of the IPv6 ACL access list to be configured.
Specifies the name of the ACL MAC access list to be configured.
The name can be up to 32 characters.
Specifies the number of the ACL MAC access list to be configured.
49