D-Link DGS-510 Reference Manual page 441

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable periodic re-authentication for a port.
Example
This example shows how to enable periodic re-authentication on Ethernet port eth1/0/1.
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# authentication periodic
Switch(config-if)#
50-4 authentication timer inactivity
This command is used to configure the timer after which an inactive session is terminated. Use the no
form of this command to disable the inactivity timer
authentication timer inactivity {SECONDS}
no authentication timer inactivity
Parameters
SECONDS
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
When the inactivity timer is configured, a user session will be terminated if the session sustains no
activity for the configured period of time. If the inactivity timer is configured, it should be shorter than
the timer value configured by authentication timer re-authentication command.
Example
This example shows how to configure the inactivity timer to 240 for eth1/0/1.
Specifies to configure the timer after which an inactive session is
terminated. The range is from 120 to 65535.
438