D-Link DGS-510 Reference Manual page 471

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
Switch# configure terminal
Switch(config)# interface eth1/0/1
Switch(config-if)# switchport port-security aging type inactivity
Switch(config-if)#
52-6 port-security limit
This command is used to configure the maximum secure MAC address number on the system. Use
the no form of this command to revert to the default setting.
port-security limit global VALUE
no port-security limit global
Parameters
VALUE
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to set the limit on the port security entry number which can be learned on a system.
Example
This example shows how to configure the maximum secure MAC address number for the system.
Switch# configure terminal
Switch(config)# port-security limit global 100
Switch(config)#
Specifies the maximum number of port security entries that can be
learned on the system. The range is from 1 to 6656. If the setting is
smaller than the number of current learned entries, the command
will be rejected.
468